(WHM >> Home >> Networking Setup >> Resolver Configuration)
The Resolver Configuration interface allows you to use a configuration wizard to edit the
/etc/resolv.conf file. This file contains the nameservers that your server queries to resolve domain names into IPv4 or IPv6 addresses.
If you do not configure these resolvers correctly, your server will not connect to the Internet.
After you navigate to this interface, click Proceed to continue to the next interface.
Your server requires at least two resolver IP addresses. You can also add an optional third address.
To configure your resolvers, perform the following steps:
If your server cannot connect to the Internet after you configure your resolvers, check the